this post was submitted on 17 Mar 2025
27 points (93.5% liked)

homeassistant

16697 readers
120 users here now

Home Assistant is open source home automation that puts local control and privacy first.
Powered by a worldwide community of tinkerers and DIY enthusiasts.

Home Assistant can be self-installed on ProxMox, Raspberry Pi, or even purchased pre-installed: Home Assistant: Installation

Discussion of Home-Assistant adjacent topics is absolutely fine, within reason.
If you're not sure, DM @GreatAlbatross@feddit.uk

founded 2 years ago
MODERATORS
GreatAlbatross@feddit.uk
greatalbatross@lemmy.world
27
Bed Occupancy Sensor? (lemmy.ml)
submitted 7 months ago by Practical_Plan_2560@lemmy.ml to c/homeassistant@lemmy.world
40 comments fedilink hide all child comments
 

Anyone try to build a bed occupancy sensor integrated with Home Assistant? I've looked into load sensors but all of them seem to have pretty small weight limits (low enough to where I don't think it would even support the empty bed).

What devices/sensors have you used for this? And what does your setup look like?

you are viewing a single comment's thread
view the rest of the comments
[–] Panq@lemmy.nz 3 points 7 months ago* (last edited 7 months ago)

You're right in that it's a useful tool for various kinds of abuse, but so is almost every useful home automation/home security sensor.

The most obvious/useful use cases I can see are:

  • turn on bedroom lights when the last person gets out of the bed
  • turn off whole house lights when the last person gets into bed.

Both should be easy with load cells under the bed legs but rather difficult otherwise.

(Useful assuming a household of two adults in one bed that is).