this post was submitted on 19 Mar 2025
219 points (93.3% liked)

hmmm

6143 readers
313 users here now

For things that are "hmmm".

Rule 1: All post titles except for meta posts should be just plain "hmmm" and nothing else, no emotes, no capitalisation, no extending it to "hmmmm" etc.

founded 2 years ago
MODERATORS
 
all 50 comments
sorted by: hot top controversial new old
[–] Coelacanth@feddit.nu 113 points 3 months ago (4 children)
[–] Mastema@infosec.pub 45 points 3 months ago (1 children)

Yeah. I gotta say I came in here to see what the problem was. These things support a ton of weight and, while it may not be beautiful, it isn't going anywhere.

[–] finitebanjo@lemmy.world 3 points 3 months ago (1 children)

It's not a longterm solution. If they could just put a pin through the pole or add a beam to support the weight then it might hold but as is this is far too temporary to be considered safe.

[–] TheFriar@lemm.ee 1 points 3 months ago (1 children)

Where are you getting that information? This is the same hardware used to build stadium seating in more local venues.

[–] finitebanjo@lemmy.world -1 points 3 months ago (1 children)

It doesn't take a rocket scientist. Gravity is pulling down, the clamps are only holding via very strong friction and metal will expand or contract in different temperatures (although it's unlikely to change much indoors). Add any form of support from below and it will become as strong and reliable as you could ever want. Don't add any form of support and someday, in the middle of the dark night, you're going to slide and potentially launch yourself into floor headfirst if you're not careful.

Murphy's Law - Anything that can go wrong will go wrong.

[–] MehBlah@lemmy.world 1 points 2 months ago (2 children)

You have never worked construction and have never seen how much they can hold up. Nothing wrong with that.

load more comments (2 replies)
[–] A_Union_of_Kobolds@lemmy.world 19 points 3 months ago* (last edited 3 months ago)

Yeah I was expecting them to be zip tied or some shit. I'd do jumping jacks on this zero hesitation as long as it's supported to a stud.

I wouldn't mind some kind of lip around the edge of the board holding the mattress but it's not gonna go anywhere. That would mostly just be to keep your phone etc from sliding off.

Lmao I just realized I'm reinventing the jail bunk

[–] kokope11i@lemmy.world 16 points 3 months ago (3 children)

I've only been here a few weeks but OP looks like the GallowBoob of Lemmy.

[–] GluWu@lemm.ee 17 points 3 months ago (1 children)

Lemmy is actually only 3 people. Picard, pugjesus, and flyingsquid. Every other user is just an alt for one of us.

[–] TonyTonyChopper@mander.xyz 3 points 3 months ago

TPM is nothing like that leech. They just post a lot

[–] straightjorkin@lemmy.world 8 points 3 months ago

You gotta drill some vent holes in the plywood so the mattress doesn't get moldy, but otherwise this is a valid set up

[–] DScratch@sh.itjust.works 39 points 3 months ago (1 children)
[–] PP_BOY_@lemmy.world 8 points 3 months ago

Too colorful for that

[–] Asafum@feddit.nl 24 points 3 months ago (1 children)

"cozy feel, utilities not included, $2400/month"

[–] KittenBiscuits@lemm.ee 6 points 3 months ago

"Lots of storage space!"

[–] ramenshaman@lemmy.world 19 points 3 months ago (1 children)

Looks better than the loft bed I built in college

[–] billwashere@lemmy.world 3 points 3 months ago (1 children)

Yeah same here. It’s a wonder we didn’t kill somebody.

[–] ramenshaman@lemmy.world 4 points 3 months ago (1 children)

I studied mechanical engineering so if I had killed someone with my bed frame then I might have felt some obligation to switch majors.

[–] billwashere@lemmy.world 6 points 3 months ago (1 children)

CS major here. It’s hard to kill people with com…. wait never mind. 🤣

[–] ramenshaman@lemmy.world 1 points 3 months ago

Props on the successful build then. There have been a handful of moments where I've cringed in fear while watching a software engineer use power tools.

[–] lnxtx@feddit.nl 15 points 3 months ago (2 children)

If it's stupid and works, it isn't stupid.

[–] glitchdx@lemmy.world 12 points 3 months ago

this isn't stupid though, it's effective and practical.

The old axom however is a flawed notion. If it's stupid and it works, it's still stupid and you're lucky you didn't hurt yourself.

[–] absGeekNZ@lemmy.nz 2 points 3 months ago

Those are steel scaffolding poles and clamps....even has end caps. As long as the clamps nuts are torqued correctly, that is not anywhere.

[–] nimble@lemmy.blahaj.zone 15 points 3 months ago

It's not pretty but it's functional. Should get some bed sheets though

[–] skillissuer@discuss.tchncs.de 12 points 3 months ago

Pitch it as a modular living quarter system repairable under resource-constrained field conditions and any army will buy it (it also simplifies logistics)

[–] CidVicious@sh.itjust.works 9 points 3 months ago (1 children)

A loft like this is pretty typical in a dorm type situation. Am I missing something else?

[–] Appoxo@lemmy.dbzer0.com 1 points 3 months ago

The way the bed is mounted?

[–] dastechniker@lemmy.world 8 points 3 months ago (1 children)

Ok, what am I missing here? This just looks like a bed scratch built from clamps and poles of some kind.

[–] MY_ANUS_IS_BLEEDING@lemm.ee 9 points 3 months ago (1 children)

Scaffolding. And the hmm is that it's a bed made from scaffolding.

[–] dastechniker@lemmy.world 1 points 3 months ago

Thanks. Looks sturdy to me!

[–] LetterboxPancake@sh.itjust.works 7 points 3 months ago

I mean, the clamps are ugly, and I would fear to rip my skin up. But besides that, I dig it.

[–] finitebanjo@lemmy.world 7 points 3 months ago* (last edited 3 months ago)

I'm sorry but you need to put pins through those poles or at least a wooden board beneath the load. I don't care what the friction is, this won't hold forever.

[–] EvolvedTurtle@lemmy.world 6 points 3 months ago

I wish I had higher ceilings in my room I would absolutely do this

[–] Num10ck@lemmy.world 5 points 3 months ago

why not add some ladder steps? some long bolster pillows?

[–] Mouselemming@sh.itjust.works 4 points 3 months ago

Judging by the bookshelves, I think you'd bonk your head trying to get into or out of those chairs. The bed would be safe for sleeping but you'd want to be careful about lively activities that might slide the board off to the right of the photo. Given the rest, and the fact it would be a pain to arrange sheets and pillows, that's probably not going to be an issue, though.

[–] 10001110101@lemm.ee 4 points 3 months ago

Looks expensive.

[–] JoShmoe@ani.social 3 points 3 months ago (1 children)
[–] unexposedhazard@discuss.tchncs.de 3 points 3 months ago (1 children)

For what exactly? This structure looks like a bit sus. Has some alternate uses for sure.

[–] JoShmoe@ani.social 4 points 3 months ago (1 children)

Building a fort of course. What else is a bed good for?

[–] unexposedhazard@discuss.tchncs.de 4 points 3 months ago* (last edited 3 months ago)

Yes, yes of course, a fort. That is what i was thinking of.

[–] PurpleClouds@lemmy.world 3 points 3 months ago

looks like my mates house. Only downside I see is that you need ventilation on the mattress or it will mold.

[–] ladicius@lemmy.world 2 points 3 months ago (2 children)

The rail is unnecessary. Nobody falls out of beds.

[–] NoSpotOfGround@lemmy.world 6 points 3 months ago

Nobody who can still talk afterwards.

[–] qarbone@lemmy.world 2 points 3 months ago

That's the head~~board~~ bar. The headbar.

[–] MehBlah@lemmy.world 2 points 2 months ago

When I was in my early twenties I slept on a scaffold bed much like that more than job. It was usually in a cargo container with nine other people. It was effectively free lodging and I was working seven days a week. Twelve hours a day with overtime.

Good times and great pay.