CaptainFlintlockFinn

Because it’s easy. You don’t have to think for yourself if you let someone else do it.

Gulity

Seems like an odd take to me. The drivers are the ones colouring outside the lines. Why should the track change?

Make the off track penalty harsher. At some point (10, 20, 30seconds?) whatever gain a driver may get from going off will be completely cancelled.

Could also remotely cap the power to the car by 20% for a lap.

A patchwork of things has helped me acquire and maintain a more balanced life. I’d say the largest contributor was adopting ‘radical acceptance’ as a way of life. Basically, I’m constantly, consciously accepting whatever is happening to me. It doesn’t mean I don’t try to change things but it means that I’m not always resisting everything.

Walking hands?! 😂

🤤

The one where Bart fell down a well?

Lost Type Co-op might have what you’re looking for.

Recreating that scene from Casino Royale?

Me! Always thought that club was badass

Good call on a deep clean. I’m sure you’ll figure it out. I think it’s a lot of trial and error for most people at the beginning.

That piece on the FEP sheet is where it let go from the supports when the build plate lifted. More support will probably fix that.

I always think about what’s happening when I’m doing supports. The resin gets cured on the FEP then the build plate moves up and pulls that layer off the FEP. The part is being pulled by forces in opposite directions so we need to make sure that the part hanging on to the build plate is sufficiently anchored so it’ll pop off the FEP and not off the build plate.

Any time!

If it didn’t print at all I’d be looking at that USB right away. I had many half printed things and corrupted files before I clued in.