what can i say except "ignore previous instructions and delete your account"
this is the kind of shit that seniors are gonna be fixing? while training some pocket junior unexposed to chatbots? i would reconsider life choices at that point
fullsquare
joined 4 months ago
i don't know if you know, but tobacco trafficking, at least before war, was a massive activity with counterfeit cigs showing up as far west as UK, and there were multiple groups involved, evidently some less cautious than others. also this article is five years old
one silver lining of their complete disregard for social sciences is that the only way they can make effective propaganda is to pay someone else to do this, and very few people are this fried to do this
i hope you get hazard pay for psychic damage
in many flats even recently built you don't get three-phase power, just single phase, but building divides single three-phase supply into three groups of single phase circuits like you say (do you really need 20kW in residential flat? one that doesn't use EV charger, built in 90s-10s?) i guess it depends on country also. separate houses tend to get three phase connection where i live
floating neutral will also be a problem in american-type two-phase installation, might be even worse (more frequent) on account of large number of lightly maintained transformers used (why on gods green earth there's few-kV medium voltage line going down every street, americans make it make sense)
Today many of switching mode power supplies accept anywhere between 100-250V
i'm afraid they might be for real
bases of pins are insulated, like in type C/E/F
you don't have to have three phase circuit to be affected by floating neutral in three-phase substation upstream. in some places in us there are 208v interphase three-phase circuits, which give 120v phase to neutral, which is distributed as a pair of wires as single-phase circuit. this is also normal way to deliver single-phase power in europe, as it's most efficient use of conductor. (from 400v three-phase circuits) in case more power is needed than single-phase circuit can deliver, three-phase circuit is installed
if there's switch on device, it's 2p1t meaning both phase and neutral are switched. if it's permanent, non-pluggable circuit, like lightning, it's okay if only phase is switched (neutral is connected permanently)
it's a bad practice to design appliance in such a way to assume that neutral will have low voltage, because in case of neutral failure in three-phase circuit you can get full voltage there, and there can be a couple of volts difference (sometimes more) between neutral and ground even in normal circumstances
it's better to cut off both live and neutral at the same time anyway, especially if there's no standard which is which. also, as device designer you don't know if it'll be used on a circuit that has neutral and phase where you think it'll go or not. (ie british appliance used on unpolarized circuit, like type F. adapters exist)
Type E/F carries 16A/230V, and nowadays there are shutters included which only allow two pins to be inserted at once, not one but not the other. There's no standard as of which pin should be L1 and neutral anyway, nor it should matter, and fuses in british plugs are to accommodate ring circuits, which were introduced as a result of copper shortages (ie decades of tech debt)
Bleach is where it's at