I was planning to set transcoding on the M.2 by using a Pi M.2 Hat board. However, since the M.2 is already there, should I just use it to run the OS and downloads, too, or just use it as a transcoding consumable and media drive? This Pi 5 has 16Gb of RAM, so it might handle every bit of the transcoding regardless, but I have not tested it. I'm also concerned about latency between the main Pi board and the hat, connected with a flexible circuit board cable.

Also, anyone have issues with media storage on external drive when using Plex/media servers?

Equipment has been ordered but has not been delivered yet. Should come the next few days.

you are viewing a single comment's thread
view the rest of the comments

[–] jabjoe@feddit.uk 1 points 21 hours ago

If you do use an SD card, use an official one rather than a random one. Not all SD card are the same and the official ones have been selected for this use.

This helps with wear and the power loss issue, which is the biggest issue with them.

When SD write, they shuffle which block is which to share out the writes. If power is lost in the middle of this shuffle, you get a new type of corruption no file system can handle. This is why you must shutdown anything running from an SD card, not just yank the power.